Product Specifications /Features
Used for plaster wallboard finishing and texturing. Do not
mix with other material.
If the joint compound is dry,carefully add water to read
the desired consistency.The best way is 1kg jointing
compound with 550ml water.
1 Apply the compound into any gap between the boards and
fill the taper.Cut a piece of tape and press into the
joint.cover the tape with the compound,and remove the
redundtant,make sure the joint keep the same level with
the surface,the first joint?s width is 100-120mm.
2 After the first coat is set and and dried apply a further
coat,extending 50mm to 60mm on each side.Ensure that the
coat is tight and featured into the board surface.
3 Once the second coat is set and dried apply a final coat
extending 50mm to 60mm on each side ,ensure that it is
tight and featured into the board surface.
4 After the final coat is set and dried ,the joint should
be lightly sanded using 120 grit paper held in hand or
Well and High Quality Control ,
Prompt Delivery ,
New Product ,
Customer's Design and Logo are Welcome ,
Competitive Prices ,
Fit for Gifts and Premiums ,
Earth-friendly Products ,
In a Variety of Design ,
Small Order Acceptable ,
ODM Accepted ,